Box development/improvement

Here is the last stage of my box development. Through my laser cut journey, I have laser cutter 15 different pieces of the main city stand. Some of them were broken, because of the wrong settings. Some of them were not good quality, some of them did not have the structure which I wanted to see. Some of them did not have embossery. But after all failed attempts, I managed to create 3 perfect pieces. On the pictures below the whole process of the last session in the workshop.

On this stage I tried if the gaps are suitable for thw size of the actual (3) logo. Unfortunately, one of them just stuck in the gap, while I was trying to take if off, it broke. 

The piece from white acrylic with gaps is the top of the stand. 

Here  I have changed the size of gaps so then it will not brake again.

The sketch of the future box. The plan how it should be. 

Here is the result of failed attempts.

After I cut all pieces, I used spray for cleaning acrylics. 

Here is the spray. Antistatic foaming cleaner. 

After I printed 9cut) all the pieces, I used a plastic workshop to glue them together. I used special glue for that. 

 In my next post I will show the results of the photosession.